Patton-electronic SmartNode 4830 Series Instrukcja Użytkownika Pobierz pdf (Strona 29)

Planning the installation 29

SmartNode 4830 Getting Started Guide 3 • Hardware installation

Planning the installation

Before you start the actual installation, we strongly recommend that you gather all the information you will

need to install and setup the device. See table 3 for an example of what pre-installment checks you might need

to carry out. Completing the pre-installation checks enables you to install and set up your VoIP IAD within an

existing network infrastructure with conﬁdence.

Note When setting up your VoIP IAD you must consider cable-length lim-

itations, and potential electromagnetic interference (EMI) as deﬁned

by the applicable local and international regulations. Ensure that your

site is properly prepared before beginning installation.

Before installing the VoIP IAD device, the following tasks should be completed:

• Create a network diagram (see section “Network information” on page 31)

• Gather IP related information (see section “IP related information” on page 31 for more information)

• Install the hardware and software needed to conﬁgure the SmartNode. (See section “Software tools” on

page 32)

• Verify power source reliability (see section “Power source” on page 32).

When you ﬁnish preparing for your VoIP IAD installation, go to section “Installing the VoIP IAD” on page 32

to install the device.

Mains Voltage: Do not open the case when the power cord is connected. For

systems without a power switch, line voltages are present within the power

supply when the power cord is connected. The mains outlet that is utilized to

power the SmartNode router shall be within 10 feet (3 meters) of the device,

shall be easily accessible, and protected by a circuit breaker.

WARNING

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 88 89

Brak uwag

Patton-electronic SmartNode 4830 Series Instrukcja Użytkownika Strona 29