Patton electronic SMARTNODE 5400 Instrukcja Użytkownika Strona 17

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 61
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 16
SmartNode 5400 rear panel 17
SmartNode 5400 Getting Started Guide 1 • General information
Table 3. Rear panel ports
Port Description
WAN ETH 0/0
Auto-MDX Gigabit-Ethernet port, RJ-45 (see
figure 1
), connects the unit to an Ethernet
WAN device (for example, a cable modem, DSL modem, or fiber modem). Note:
Only full duplex modes are supported.
LAN ETH 0/1
Auto-MDX Gigabit-Ethernet port, RJ-45 (see
figure 1
), connect the unit to an Ethernet
LAN (for example, a PC, printer, or wireless bridge). Note: Only full duplex modes
are supported.
Console
Used for service and maintenance, the Console port (see
figure 1
), an RS-232 RJ-45
connector, connects the product to a serial terminal such as a PC or ASCII terminal
(also called a dumb terminal).
Reset
The reset button (see
figure 1
) has three functions:
Restart the unit with the current startup configuration—Press (for less than 1 second)
and release the Reset button to restart the unit with the current startup configuration.
Restart the unit with factory default configuration—Press the Reset button for
5 seconds until the Power LED (see
figure 2
on page 18) starts blinking to restart
the unit with factory default configuration.
Restart the unit in bootloader mode (to be used only by trained SmartNode tech-
nicians)—Starting with the unit powered off, press and hold the Reset button as
you apply power to the unit. Release the Reset button when the Power LED starts
blinking so the unit will enter bootloader mode.
G.SHDSL port
(option)
Provides up to 11.4 Mbps (on 4 wires) and 5.7 Mbps (on 2 wires) symmetrical
throughput, supporting ATM QoS. Supports multiple PVC and DSLAM interoperabil-
ity. The G.SHDSL LEDs are located on either side of the DSL port. ACT (when lit or
blinking) shows Activity, and LINK (when lit) shows that the DSL port is connected.
Przeglądanie stron 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 60 61

Komentarze do niniejszej Instrukcji

Brak uwag